Arch Fenders
Click on image Click image to enlarge
The V-fender is the most commonly used moulded fender type and is available in 3 different cross sections, SV, SX and SH. The main difference is the width of the front face and resulting surface load. Each type can be equipped with an additional embedded steel plate in the fender head. This allows the installation of a low friction PE-rubbing plate, a steel fender panel or the mounting of the fender unit behind a pile construction. V-Fenders:
Product Description The V-fender is the most commonly used moulded fender type and is available in 3 different cross sections, SV, SX and SH. The main difference is the width of the front face and resulting surface load. Each type can be equipped with an additional embedded steel plate in the fender head. This allows the installation of a low friction PE-rubbing plate, a steel fender panel or the mounting of the fender unit behind a pile construction. V-Fenders:
Product Category Marine
Product Specification The V-fender in available in standard heights from 250 to 1.000 mm and standard length ranging from 1.000 to 3.500 mm (Special lengths, diameters, fixing arrangements or end-chamfers available upon request), each in 3 main different hardness grades. (Intermediate rubber grades are available upon request)



 Leave Your Message 
Product Specification
The V-fender in available in standard heights from 250 to 1.000 mm and standard length ranging from 1.000 to 3.500 mm (Special lengths, diameters, fixing arrangements or end-chamfers available upon request), each in 3 main different hardness grades. (Intermediate rubber grades are available upon request)
Related Products
SPC CONE FENDERS
CSS CELL FENDERS
V FENDERS